PatternMaster v6 Bust Point/Dart Point Settings

Settings Defined

The Dart Point Vertical and Dart Point Horizontal settings in PatternMaster v6 determine the location of the marked bust point and the dart point locations for the side bust and front waist darts. The bust point is the fullest part of the bust mound. It is not always were the nipple is positioned in your bra.

The bust point (as determined by the two settings) is marked with a circle on the bodice front pattern. The dart point for the side bust dart and the front waist darts are measured out and down from this marked circle by the amount specified in the Upper Front Dart Length setting.

See the on-screen Settings Help for illustrations on how to take the Dart Point Vertical and Dart Point Horizontal measurements.

v6 dart point

Once you have tested your fitting garment and are satisfied with the position of the bust point and front darts, you can set defaults for these settings so that all of your styled patterns will be drafted accordingly.

Default Settings

Set these dart defaults as follows:

  1. While on the Fit Garments screen, choose View/Set Defaults from the File menu.
  2. v6 dart point

  3. Click on the Darts Tab.
  4. v6 dart point

  5. Select the desired amount for each setting from the drop down box.
  6. v6 dart point

  7. Check all of the check boxes as shown below and press the Save button on the Defaults screen.
  8. v6 dart point

Copyright Wild Ginger Software, Inc. 1995-present. All rights reserved.

This publication, or any part thereof, may not be reproduced in any form, by any method, for any purpose, without the express written consent of Wild Ginger Software, Inc.